Testing the Integration Instance

In this article, we will explain how you will be able to try the Push and Pull methods between BSS and external integration systems through the custom integration connector.
As an example, we will use a Microsoft Dynamics Navision integrator to describe the procedure. 


Testing Process of the Custom Integrator


To test BSS and MS Dynamics Navision, you have to follow the below steps:

  1. Go BSS > Setup > Administration > System Options and select Systems Setup
  2. On the custom created integrator select Edit integration


  3. Go to the bottom of the page to the Api Tester section

    1. On the Provider Instance, select the instance name you have created. ( for example, "Test Instance")
    2. In the Module  section, you can find all the entities you can sync.
    3. In the Object ID  section, you have to input the ID of the object you want to try

      1. If you want to try the Push method find the ID with one of the below ways.

      2. If you want to try the Pull method find the ID into the External System.

  1. Click on Push Data or Pull Data to test 
    1. Select Push Data to push data from BSS into the Navision system. 
    2. Select Pull Data if you want to pull data from External System to the BSS system. 

Push and Pull method Results

  1. If the method is has been completed successfully, you will receive an "OK" message.

  2. If the method is not successful, you will receive an informational error message like the below:





Finding Object ID in BSS


In this section, we describe how you will locate the ID of each module to test the Push and Pull methods. The ID of each entity can be found outside of Setup Mode if you go to each entity in BSS and on the address bar except Payments ID.




Checking on Logs


To check if the below actions have been completed normally, you can use the Log Mechanism

Table of Contents